Adjusting The Equalize-Charging Mode Time; Diode-Splitter Charge Voltage Compensation - Victron energy SKYLLA-TG 24/80 Gebrauchsanweisung

To change the boost-voltage:
Place DIP-switch 7 "Eq2" to the right and place DIP-switch 8 "R
boost" to the left. The charger switches into the boost-charge mode.
Place DIP-switch 4 "fine" to the left position in order to accurately
adjust the output voltage.
Measure the boost-voltage on the charger output by using a precision
voltage meter.
Adjust the boost-voltage by turning the "V boost" potentiometer
until the recommended voltage is reached.
Replace DIP-switch 8 "R boost" to the right.
Correct the equalize time by moving DIP-switch 7 "Eq2" and 6 "Eq1".
Place DIP-switch 4 "fine" to the right position. In this position the output
voltage is less sensitive to influence of temperature.
4.3

Adjusting the equalize-charging mode time

The duration of the equalize-charge mode can be changed to fit the specifications of the
battery. The duration of the equalize-charge mode can be set to 0, 4, 8 or 12 hours. When
selecting 0 hours, the charger will skip the equalize-charge mode and will directly switch
into the float-charge mode. The standard equalize-time is 4 hours.
According to the table below the duration of the equalize-charge mode can be set by
moving the DIP-switches 7 "Eq2" and 6 "Eq1" in the corresponding way:
0 hours
4.4

Diode-splitter charge voltage compensation.

If a diode-splitter (Victron Energy Argo) is connected to the Titan
charger the charge voltage have to be raised to compensate for the
voltage loss over the diode-splitter.
If the voltage-sense option is used, do not use the diode-splitter
compensation. When both options are used simultaneously the output
voltage will be too high.
To select the diode-splitter option:
Place DIP switch 5 "split" to the left.
4 hours 8 hours 12 hours
Manual Titan
19