Options - Victron energy SKYLLA-TG 24/80 Gebrauchsanweisung

4.

OPTIONS

The Titan charger is factory set to standard values. Some of these standard values can be
changed by a qualified electrical technician into customised values. This chapter describes
which values can be changed and how to change them.
The cover of the Titan may only be removed by a qualified
technician. Before obtaining access to the Titan the mains supply
circuit must be disconnected.
There is a dangerous voltage present on some of the metal parts
inside the battery charger.
Attention ! The value of the potentiometers I, Vboost and Vfloat
may only be adjusted by a qualified electrician. The remaining
potentiometers may not be adjusted at any case.
Opening of the battery charger cabinet
In order to change the standard values the front of the charger has to be removed.
Disconnect the mains from the charger and wait two minutes.
Unscrew the 4 screws on the front of the cabinet, see illustration 6.
Remove the front panel of the battery charger.
Adjustments can be made by means of turning a potentiometer or by changing the position
of a switch on the DIP-switch.
See illustration 7 for the location of the DIP-switch and the potentiometers.
Illustration 6.
Removing the front.
DIP switch
I
Vboost
Vfloat
Illustration 7.
Location of the DIP-switch and potentiometers.
Manual Titan
17