Victron energy SKYLLA-TG 24/80 Gebrauchsanweisung Seite 15

Connecting the starter battery
The starter battery has to be connected using wire with a core of at least 1.5 mm
Connect the positive (+) battery-pole to the right side of the starter battery connector, see
illustration 3.
Connect the negative (-) battery-pole to the left side of the starter battery connector, see
illustration 3.
Connecting the mains
Check if the battery is already connected to the charger.
Remove the front of the battery charger to access the AC input connector.
Connect the mains PE cable (green/yellow) to the AC input connector located on the
circuit board, see illustration 4.
Connect the mains neutral cable (blue) to the AC input connector.
Connect the mains line cable (brown) to the AC input connector.
Plug the mains cable into the mains socket. Make sure that the mains socket is connected
to earth. The connection to the earth of the mains has to be according to applicable safety
standards.
Illustration 4.
Location of the
AC input connector.
AC input connector
PE connection
neutral connection
line connection
Manual Titan
2
.
N L
13