piezosystemjena d-Drive Bedienungsanleitung Seite 70

monsrc monitor output
(0 = default)
cl open loop / closed loop
kp proportional term
ki integral term
kd differential term
sstd set default values
notchon notch filter
notchf notch filter frequency
notchb bandwidth (-3dB)
Ipon low pass filter
Ipf low pass cut frequency
gfkt internal function generator
(see table 12)
gasin generator amplitude sine
gosin
amplitude offset sine
gfsin generator frequency sine
gatri generator amplitude triangle
gotri amplitude offset triangle
gftri
generator frequency triangle
gstri symmetry of triangle
garec generator amplitude rect.
gorec
amplitude offset rectangle
gfrec generator frequency rectangle
gsrec symmetry of rectangle
ganoi
generator amplitude noise
gonoi
amplitude offset noise
gaswe generator amplitude sweep
goswe amplitude offset sweep
gtswe
generator sweep time
sct scan type
ss start scan
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezojena.com
70
0 = position in closed loop
1 = command value
2 = controller output voltage
3 = closed loop deviation incl. sign
4 = absolute closed loop deviation
5 = actuator voltage
6 = position in open loop
0 = open loop
1 = closed loop
0 to 999.0
0 to 999.0
0 to 999.0
------
0 = off
1 = on
0 to 20000 [Hz]
0 to 20000 (max. 2 * notch_fr) [Hz]
0 = off
1 = on
1 to 20000 [Hz]
0 = off
1 = sine
2 = triangle
3 = rectangle
4 = noise
5 = sweep
0 to 100 [%]
0 to 100 [%]
0.1 to 9999.9 [Hz]
0 to 100 [%]
0 to 100 [%
0.1 to 9999.9 [Hz]
0.1 to 99.9 [%] default = 50 %
0 to 100 [%]
0 to 100 [%]
0.1 to 9999.9 [Hz]
0.1 to 99.9 [%] default = 50 %
0 to 100 [%]
0 to 100 [%]
0 to 100 [%]
0 to 100 [%]
0.4 to 800 [sec/decade]
0 = scan function off
1 = sine scan
2 = triangle scan
without value: request scan state
1 = starts scan