Maintenance And Inspection; Environmental Conditions; Instructions For Checking The Function Of The System / Quick Start - piezosystemjena d-Drive Bedienungsanleitung

6.3 maintenance and inspection

CAUTION!

Before cleaning the exterior box of the voltage amplifier, turn off the power switch and
unplug the power plug. Failure to do so may result in a fire or electrical shock.

Clean the exterior box using a damp cloth that has been firmly wrung-out. Do not use
alcohols, benzene, paint thinner, or other inflammable substances. If flammable substances
come into contact with an electrical component inside the voltage amplifier, it may result in
a fire or electrical shock.

6.4 environmental conditions

The amplifier can be used:

indoors only

at an altitude up to 2000 m

at a temperature of 5 ... 35 °C

at a relative humidity of 5 ... 95% (non-condensing)
The recommended environmental conditions:

indoors only

at an altitude up to 2000 m

at a temperature of 20...22 °C

at a relative humidity of 5 ... 80% (non-condensing)

7 instructions for checking the function of the system / quick start

When you open the package, please check to make sure all the necessary parts are included
(see packing list) and nothing is damaged.
Check the electronics and the actuator for any visible damage:

The top and bottom plates of the actuator (if it does not have another shape) should be
parallel each to each other, and not contain any scratches.

If there is any damage to the system please contact our local representative immediately!

If the packaging material is damaged please confirm this with the shipping company.

Ensure that the main voltage supplied in your country is the same as the one installed for
the system (Check the voltage label on the backside of the power supply).

The power switch should be in the off position.

Connect the power supply.

Connect the piezo actuator by using the D-SUB 15pin connector. Be sure that the cables
are connected properly to the electronics.

Switch on the power supply on the back side (Standby).

Switch on the system by pressing the POWER button on the EDS. The green
"READY" LED indicates the power supply is working.

It is followed by a short self test of all parts.

All of the yellow LEDs included in the EVD50 will blink. The green "ON" LED will shine
permanently. If there is an actuator plugged into the D-SUB 15pin and the amplifiers are
working, the LED's will switch off after about 3 seconds.
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezojena.com
49