Installation, Power Supply; Operation - piezosystemjena d-Drive Bedienungsanleitung

6.1 installation, power supply

RISK OF ELECTRIC SHOCK

Do not insert or unplug the power plug with wet hands, as this may result in electrical
shock.

Do not install in rooms where inflammable substances are stored. If flammable substances
come into contact with electrical parts inside, it could result in fire or electrical shock.

Do not damage or modify the power cord. Also, do not place heavy objects on the power
cord, or pull on or excessively bend it, as this could cause electrical damage and result in a
fire or electrical shock.

Always grasp the plug portion when unplugging the power cord. Pulling on the power cord
may expose or snap the core wire, or otherwise damage the power cord. If the cord is
damaged, this could cause an electricity leak and result in a fire or electrical shock.
CAUTION!

Do not use accessories other than the ones provided (e.g. power cord). Only plug the
power cord into grounded power equipment and sockets.

Do not place heavy objects on any cables (e.g. power cords, sensor cables, actuator
cables, optical cables).

Do not block ventilated openings or place the units near a radiator, oven, or other heat
sources.

Plug in the power cord completely so that it cannot loosen inadvertently.

Leave sufficient space around the power plug so that it can be unplugged easily. If objects
are placed around the power plug, you will be unable to unplug it in an emergency.

Install the system so that the on/off-switch is easily accessible at all times.

The power plug is the cut-off point to the main power supply.

6.2 operation

RISK OF ELECTRIC SHOCK!

Do not open the units! There are no user serviceable parts inside and opening or removing
covers may expose you to dangerous shock hazards or other risks. Refer all servicing to
qualified service personnel.

Do not spill inflammable substances inside the voltage amplifier. If these items come into
contact with an electrical component inside the voltage amplifier, it may result in a fire or
electrical shock.
CAUTION!

If the voltage amplifier emits smoke, high heat, or unusual smells, immediately turn off the
power switch and unplug the power plug from the outlet. Then contact our technical service.
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezojena.com
48