Second Balance Interface; Rs 232C Interface - KERN CFS Betriebsanleitung

7. Password input for menu block „
 Press
,
board to enter the desired code and acknowledge with

is displayed, request to repeat the password input.
Enter code anew and press
input, is displayed, at wrong input
case repeat the code input.

15 Second balance interface

When using as counting system, the weighing bridge must be connected with a
suitable cable via the second-balance interface.
9 pin d-subminiature bushing of the
balance
Pin no.:
Pin 1 or 2
Pin 4 or 5
Pin 7
Pin 8

16 RS 232C interface

The balance is typically equipped with a RS 232C interface. Weighing data can be
edited according to menu setting or automatically or by pressing
via the interface.
This data exchange is asynchronous using ASCII - Code.
The following conditions must be met to provide successful communication be-
tween the weighing balance and the printer.
Use a suitable cable to connect the weighing balance to the interface
of the printer. Faultless operation requires an adequate KERN interface
cable.
Communication parameters (baud rate, bits and parity) of balance and
printer must match. Detailed description of the interface parameters
see chpt. 11.2, Menu block "
CFS/CCS-BA-e-1215
"
is displayed. Use the numeric key-
to acknowledge. At successful
Balance connection
EXC+ (5V)
EXC– (0)
SIG–
SIG+
.
. In this
Connection of weighing bridge KERN
KFP
see labelling of load cell
".



45