KERN CFS Betriebsanleitung Seite 84

 Press , tolerance control is started. The  symbol over
 Determine the average piece weight (see chpt. 10.1 or 10.2), place the weighing
goods and check using the tolerance mark , if the number of the placed pieces
is under, within or above the specified tolerance.
Display of tolerance mark , if weighing goods are under the specified tolerance
Display of tolerance mark , if weighing goods within the specified tolerance
Display of tolerance mark , if weighing goods above the specified tolerance:
The indetermination if the goods to be weighed are within the tolerance limits, can
additionally be given by an acoustic signal (menu item „
 For tolerance control, also only one limit value can be set.
 If both limit values are deleted, the tolerance control is deactivated.
34
appears.
„ see chpt. 12.2)
CFS/CCS-BA-e-1215