Herunterladen Inhalt Inhalt Diese Seite drucken

Montagehinweise; Montage- Und Wasseranschluss; The Following Must Be Observed; Installing The Appliance - clage MDX 3..7 series Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Montagehinweise

Die Montage erfolgt direkt an die Anschlussrohre der
Sanitärarmatur in einem frostfreien Raum. Wir garan-
tieren einwandfreie Funktion nur bei Verwendung von
CLAGE Armaturen und Zubehör. Bei der Installation
beachten:
• DIN VDE 0100 und DIN 1988 sowie die gesetzlichen
Vorschriften des jeweiligen Landes und die
Bestimmungen des örtlichen Elektrizitäts- und
Wasserversorgungsunternehmens
• Technische Daten und Angaben auf dem Typenschild
• Keine Zubehörteile in der Verpackung zurücklassen
• Für Wartungszwecke muss der Durchlauferhitzer
leicht zugänglich sein. Ein separates Absperrventil
muss installiert sein.
• Vor Anschluss Wasserleitungen gut durchspülen
• Ein optimaler Betrieb ist bei einem Fließwasserdruck
zwischen 0.2-0.4 MPa (2-4 bar) gewährleistet.
Der Netzdruck darf 1 MPa (10 bar) nicht überschrei-
ten.

Montage- und Wasseranschluss

Abb. 1
• Wandhalter mit Schrauben dübeln
(siehe Abbildung 1).
• Gerät auf den Wandhalter stecken
und einrasten (siehe Abbildung 2).
6

The following must be observed

The heater is installed as shown in the immediate vici-
nity of the outlet in a frost-free room. We guarantee
trouble-free operation only if CLAGE fittings and acces-
sories are used. Note the following during installation:
• Observe the statutory regulations of the respective
country, as well as those of the local electricity and
water supply companies.
• Check technical data and the information on the
rating plate.
• Ensure that all accessories are removed from the
packing materials.
• Easy access to the appliance shall be guaranteed
at all times. An external shut-off valve has to be
installed.
• Thoroughly rinse the water pipes before connection.
• Optimum operation is ensured at a water flow pres-
sure of 0.2 to 0.4 MPa (2-4 bar), avoiding pressures
exceeding 1 MPa (10 bar).

Installing the appliance

fig. 1
Abb. 2
• Secure the wall bracket to the wall with screws and
suitable wall plugs (see fig 1).
• Place the appliance on the wall bracket
and snap it into position (see fig. 2).
fig. 2

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis