Trouble Shooting - Holzmann HBS 230HQ Betriebsanleitung

19

TROUBLE SHOOTING

Disconnect the machine from the power supply prior to any checks performed
at the machine itself!
Trouble
Saw stops or will not
start
Does not make accurate
45° or 90° cuts
Band wanders during
cut
Saw makes
unsatisfactory cuts
Band does not come up
to speed
Saw vibrate excessively
Saw band runs in
opposite direction
MANY MALFUNCTIONS AND DEFECTS CAN BE AVOIDED BY LETTING THE MACHINE BE
CONNECTED TO YOUR POWER SUPPLY BY A CERTIFIED ELECTRICIAN
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Possible cause
 Overload tripped
 Saw unplugged
 Fuse blown or circuit breaker tripped
 Cord damaged
 Stop not adjusted correctly
 Angle pointer not set accurately
 Miter gauge out of adjustment
 Fence not aligned with band
 Warped wood
 Excessive feed rate
 Incorrect band for cut
 Dull band
 Band mounted wrong
 Gum or pitch on band
 Incorrect band for cut
 Gum or pitch on table
 Extension cord too light or too
 Low shop voltage
 Base on uneven floor
 Bad v-belt
 Bent pulley
 Improper motor mounting
 Loose hardware
 2 of the 3 leading phases are
switched whether in Plug or socket
TROUBLE SHOOTING
Solution
 Allow motor to cool and reset by
pushing off switch
 Check all power connections
 Change fuse or reset circuit
breake
 Change cable
 Check band with square and
adjust stop
 Check band with square and
adjust pointer
 Adjust miter gauge
 Check and adjust fence
 Select another piece of wood
 Reduce feed rate
 Change band to correct type
 Replace band
 Teeth should point down
 Remove band and clean
 Change band to correct type
 Clean table
 Replace with adequate size cord
 Contact your local electric
company
 Reposition on flat level surface
 Replace v-belt
 Replace pulley
 Check and adjust motor
 Tighten hardware
 Shut off machine immediately.
Let the connection to supply
circuit be corrected by an
electrician!
HOLZBANDSÄGE / WOOD BANDSAW HBS 230HQ
Seite 45