Cable Assembly; Putting Into Operation - Abicor Binzel 350GC Betriebsanleitung

6 Putting into operation

5.1 Torch neck

5.2 Cable assembly

6 Putting into operation
EN - 8
All elements together form an operating unit which provides a plasma arc for
welding when supplied with the appropriate operating resources. The welding
wire required for welding is fed through the cable assembly and the torch neck
all the way to the contact tip. The contact tip transmits the welding current to the
welding wire, producing an arc between the welding wire and work-piece. The
welding arc and the molten pool are protected by an inert gas (MIG) or an
active gas (MAG).
The standard torch necks of the ABIROB
geometries straight and 35°bent. Special designs will be manufactured upon
request depending on the application. They can be connected to the cable
assembly at the burner via the uniform interface at the connecting module.
The air-cooled cable assembly provides the welding torch will all components
required for welding such as welding current, shielding gas and air. The
machine-side connection is available in Panasonic
ABICOR BINZEL KZ-2.
 4 Scope of delivery on page EN-6
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the compressed air supply.
• Pull the mains plug.
NOTE
• The welding torch may only be put into operation by trained personnel.
This chapter gives you all the information that must be taken into account when
putting the welding torch into operation.
ABIROB
®
350GC are available in the
®
design or with or with
®
350GC