Abicor Binzel 350GC Betriebsanleitung Seite 32

12 Disposal
12 Disposal
12.1 Materials
12.2 Consumables
EN - 16
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the compressed air supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in 8 Putting out of operation on
page EN-13.
1 Disconnect the cable assembly from the wire feed and torch neck.
2 Remove parts to be dismounted (torch seat, torch neck, equipment parts).
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the ABIROB
first must be dismounted.
 11 Dismounting on page EN-15
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
Oils, greases and cleaning agents must not contaminate the ground and not
enter the sewerage. These materials must be stored, transported and disposed
of in suitable containers. Please observe the relevant local regulations and
disposal instructions of the safety data sheets given by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the manufacturer
of the consumables.
ABIROB
®
350GC to be properly disposed of, it
®
350GC