DIRECTTECH SKIZZE Handbuch Seite 66

InSTAllATIon InSTRuCTIonS
foR DIRECTTECH CRYSTAl & DIRECTTECH mIRRoR
Delivery contents:
• 1 piece DIRECTTECH heating panel
• 2 pieces corner fastenings (brackets)
• 4 pieces threaded bolts M8
Additional accessories:
(not included in delivery)
• hexagon key
• in accordance with local conditions appropriate mounting
material
(WITH 2 PERSONS)
Installation:
1. Lay down the DIRECTTECH heating panel carefully with the glass
side on a horizontal surface (use the paperboard as supporting
underlay).
2. Place the supplied brackets on the back of the frame profile where
the square nuts (4 pieces) (Pic.1) are located for screwing.
3. Now screw the threaded bolts through the brackets into the
appropriate square nuts and ensure that the bracket has the
same clearance to the right and to the left side of the frame. Then
tighten the threaded bolts (due to mechanical manufacturing,
deviations of drilling distances might occur!).
4. Secure the bracket with the supplied hexagon nuts.
5. Now you can align the DIRECTTECH heating panel on the wall
with the screwed on corner brackets (pic.2) and take over the
drilling holes for screwing (due to mechanical manufacturing,
deviations of drilling distances might occur!).
6. Fasten the brackets with appropriate fastening material regarding
the mounting surface.
7. For electric installations, the regulations of EN/VDE and of the
local power supply company (EVU) are decisive.
Dismantling:
1. Disconnect the electrical connections according to safety instruc-
tions and technical rules.
2. The dismantling takes place in reverse sequence.
66
wITH CoRnER fASTEnInG