Data Logger; Starting The Recording; Deleting The Memory - VOLTCRAFT SL-400 Bedienungsanleitung

Data logger

Changing the interval time
You can preset the interval time of the integrated data logger from 1 to 59 seconds. In
REC mode, the data logger only records a measuring value in the prescribed interval.
To set this, proceed as follows:
- Turn the measuring device off (button 11)
- Keep the button „LIGHT" (8) depressed and turn the device on.
Keep both buttons depressed until „INT" appears on the display.
- Press the „LEVEL" button to set the interval time in seconds. Keep
the button depressed to set the value faster. The values ascend and
start again at the beginning.
- You must terminate the setting with the button „HOLD", otherwise
the value is not saved.

Starting the recording

Once the setup settings and the interval times are set, you can start the measuring
value recording.
- Turn the measuring device on (button 11), and select the desired measuring para-
meters (measuring range, filter, etc.).
- Press „REC". The recording starts. The display indicates the symbol „REC" (2G).
- You stop the recording by pressing the button „REC" again.
To prevent data loss, first switch the measuring device off when the
recording is completed (display „REC" is no longer visible).
- The recorded data can only be read out via the interface.
- If all memory slots are full, the display shows „FULL". Delete the memory after each
data transfer.

Deleting the memory

A full memory can be deleted with a key combination.
- Turn the measuring device off (button 11)
- Keep the button „REC" depressed and turn the device on. Keep
both buttons depressed until „CLR" appears on the display.
- The memory is deleted. The measuring device automatically swit-
ches back to measuring operation.
31