Operating Instructions; Lighting Instructions; Ignition Procedure - CombiSteel 7455.0999 Gebrauchsanweisung

5. OPERATING INSTRUCTIONS

5.1 LIGHTING INSTRUCTIONS

DO NOT OPERATE THE UNIT UNLESS IT HAS BEEN INSTALLED AND COMMISSIONED
BY AN AUTHORIZED PERSON.
BEFORE TURNING ON THE MAIN GAS SUPPLY, CHECK AND ENSURE THAT ALL THE
VALVES ARE IN THE "OFF" POSITION.
THIS EQUIPMENT IS DESIGNED FOR COMMERCIAL CATERING PURPOSES AND WILL
GENERATE SIGNIFICANT HEAT. HOT SURFACES WILL CAUSE BURNS. A HAZARD AND
RISK ASSESSMENT MUST BE UNDERTAKEN BY OWNERS AND ALL OPERATORS MADE
AWARE OF THESE.
NOTE: Ensure the gas supply to the equipment is turned ON.
NOTE: For your safety, the valve comes with a flame failure sensing device. If the device does not sense a flame,
gas supply to the burner will be cut.

5.2 IGNITION PROCEDURE

NOTE: Ensure the gas supply to the equipment is turned ON
1) Starting from the "0" position
Press the PILOT ★ position.
2)
3) Manually light the pilot by use of a spark gun or lighter.
Continually press the ★ button for 15 seconds. Now when the ★ button is released, the pilot flame
4)
should stay alight. If it does not, go back to step (1) and start all over again. When the automatic valve
senses that the pilot is alight, the gas flow to the main burner is opened.
5) If the pilot flame cannot be lit after repeated attempts, check out the troubleshooting page of this
manual.
6) Turn the knob to setting "1".
7) Turn the knob to the setting of your desired temperature. Please refer to the following table.
www.combisteel.com
10