3. GENERAL INFORMATION
3.1 INSPECTION
Please inspect the unit on receipt. If the unit is damaged, contact the carrier immediately and file a damage claim
with them. Save all packing materials when filing a claim. Freight damage claims are the responsibility of the
purchaser and are not covered under warranty.
3.2 OPERATOR MANUAL
This manual contains important information for your safety and the installation, operation, maintenance and
service of this equipment. Please read the manual carefully and ensure all operators of the equipment are aware
of the contents and safety requirements.
Warning: You must assess all hazards and risks associated with the operation of the equipment in your
environment and advise all operators of them.
3.3 INSTALLATION
This equipment must be installed by an authorized person in accordance with local authority, gas, electricity, and
any applicable statutory regulations and manufacturer requirements.
3.4 GAS CONNECTION
The appliance must be connected by an authorized person to the gas type specified on the unit. The gas type is
shown adjacent to the gas connection point on the rear panel and on the data plate. Connect to and use only
the correct type of gas.
3.5 GAS PRESSURE
The authorized person installing this equipment must ensure that the gas operating pressure is the same as
shown on the data plate and that there is sufficient gas volume.
3.6 COMMISSIONING
The authorized person installing this equipment must commission the equipment in accordance with local gas
safety regulations - gas leakage, operational checking, adjustments and instructing the owner on use of the
equipment are prescribed requirements.
7
www.combisteel.com