Technical Data; General Remarks - clage S 30 Gebrauchs- Und Montageanleitung

GB

Technical data

Model
Capacity
Type
Tank material
Weight
Mains water pressure
Heating
element
Heating time
Heat loss
(60° C)
The range of the water-heaters includes models prepared for being fitted
over or under the pont of use (wash-basin, sink). The models to be fitted
under the point of use called "under sink" are shown by the letter "S".

General remarks

Installation is in charge of the purchaser the Merloni Termo Sanitari spa
cannot be held responsible for the damages caused by wrong installation
and for not following instructions included in this pamphlet, particularly
on:
1) The electric connection has to be in compliance with the relative para-
grath.
2) The safety valve supplied with the apparatus has not to be tempered
with neither substituted.
3) The installation has to be carried out by qualified personnel.
Fastening
Fasten with screws to the wall the mounting bracket supplied with the
to the wall
water heater.
Hook the water heater to the bracket and pull down in order to cause the
slotting into the proper holes situated in the bracket housing.
No to bend the bracket.
7
l.
Kg.
bar
Type
Current A:
Tension V:
˜
Power W:
T 45° (h-min): 30 min 18 min 45 min 20 min 1 h 10 min 50 min
Above-sink Above-sink
Under-sink Under-sink
10 15
Mural
Fe Zn - Fe smalto
8 8,6
See rating label
corazzata
See rating label
See rating label
1200 2000 1200 2000 1500 2000
0,55/0,60 0,65/0,70
Above-sink
30
14,4
0,857-