After Use; Cleaning And Care - Silvercrest SDM 1500 B2 Bedienungsanleitung

10) When you are finished treating all of the surfaces, press the "Steam"
button
11) Set the on/off switch
12) Remove the power plug from the mains power socket.
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may
be due to the previously used cleaning fluids. Simply clean the floor again
using the steam mop. The smears should now be gone.

After use

1) Allow the appliance to cool down.
2) Remove the pad
3) Remove the water tank
4) Pull the upper cable hook
Wind the cable back around the two cable hooks
Fix the end of the power cable using the cable clip located on the cable.

Cleaning and care

RISK OF ELECTRIC SHOCK!
► Always remove the mains power plug before cleaning the appliance!
WARNING – RISK OF INJURY!
► Allow the appliance to cool down before cleaning it. Risk of burns!
CAUTION – PROPERTY DAMAGE
► When cleaning the surfaces use neither abrasive or chemical cleaners,
nor sharp or scratchy objects.
■ Empty the water tank
■ After each use, remove the pad
SDM 1500 B2
to stop steam production.
to "O". The POWER control lamp
.
from the appliance and empty it.
out a little and turn it back upwards.
after every use.
/ .
from the steam foot
goes out.
and wash it out.
│
45 ■
GB