Silvercrest SDM 1500 B2 Bedienungsanleitung Seite 47

2) Press the "Handle" release button
clicks into place.
3) Run the cable through the notch
cable does not hang down into the working area.
4) Insert the plug into the mains power socket.
5) Set the on/off switch
POWER control lamp
6) Use the MODE button
–
Press 1 x: low steam level, green control lamp
–
Press 2 x: high steam level, red control lamp
–
Press 3 x: no steam, standby, POWER control lamp
NOTE
► We recommend the high steam level especially for moisture- and heat-
resistant floor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and heat-
sensitive floor coverings, such as parquet flooring.
7) Wait around 30 seconds while the appliance heats up.
8) Press the "Steam" button
after a short time, steam is emitted through the pad
9) Wipe over the desired area.
If the water tank
NOTE
► Once the water tank
running a little while until the empty water tank
taneous flashing of the red control lamp "high steam level"
control lamp "low steam level"
–
Press the "Steam" button
–
Set the on/off switch
–
Remove the water tank
described in the section "Filling with water".
–
Set the on/off switch
–
Select the desired steam level as described above and press the
"Steam" button
│
■ 44
GB
and flip the handle upwards so that it
on the rear of the handle so that the
to "I". The on/off switch
flashes.
to select the desired level of steam generation:
. The appliance starts generating steam and,
becomes empty during use:
has been pumped empty, the pump will continue
and POWER control lamp
again to stop steam production.
to "O".
, fill it and replace the water tank
to "I".
.
lights up, the red
lights up.
lights up.
lights up.
.
is indicated by the simul-
, the green
.
as
SDM 1500 B2