Commissioning And Operation; Description Of The Appliance; Before Startup - Kärcher K 7.75 M Bedienungsanleitung

Commissioning and operation

Definition of abbreviations used:
HP = High pressure
DT = Detergent

Description of the Appliance

When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Illustrations on Page 2
1 Screws
2 Supporting foot
3 HP hose
4 HP hose drum with handle
5 DT tank
6 Dosage valve for detergent
7 ON/OFF switch for appliance
8 T-Racer bracket
9 Rubber band
10 Accessory mount
11 Handgun storage clip
12 Transport handle
13 Storage, power cord
14 Power cable with plug
15 Axle
16 Sleeve
17 Bearing wheel
18 Expanding rivet
19 Wheel cap
20 Connection for suction hose
21 Lock
22 Fine filter
23 Hose drum for water supply hose
24 Water connection
25 Water supply hose
26 Quick coupling
27 Trigger gun with safety catch
28 Spray lance with pressure regulation
(Vario Power)
29 Spray lance with dirt blaster
30 Washing brush

Before Startup

Figure A
Tools needed for installation (not supplied)
Figure B
Attach the accessory holder to the de-
vice.
Figure C
Attach the transport handle.
Insert holder for hand spray gun.
Figure D
Attach the quick coupling to the water
supply hose.
Figure E
Attach support leg.
Figure F
Attach expanding rivet to axle.
Insert expanding rivet to axle.
Figure G
First push the transport wheel, and then
the sleeve onto the axle.
Figure H
Insert the axle into the bearings.
Figure I
Always hold against axle when performing
the following steps.
First push the sleeve and then the
transport wheel onto the axle.
Attach expanding rivet to axle.
Insert expanding rivet to axle.
Figure J
Attach the wheel caps.
Figure K
Push out the safety clip in the trigger
gun using e.g. a small screwdriver.
Join HP hose and trigger gun together.
Push clip in until it engages and check
that it is securely fastened by pulling on
the HP hose.
15
English