Commissioning And Operation; Description Of The Appliance; Before Startup; Water Supply - Kärcher K 7.85 M Bedienungsanleitung

Commissioning and
operation
Definition of abbreviations used:
HP = High pressure
DT = Detergent

Description of the Appliance

When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Illustrations on Page 2
1 Transport handle
2 DT tank
3 DT tank
4 DT metering regulator
5 Accessory compartment
6 Storage, hand-spray gun
7 ON/OFF switch for appliance
8 HP hose drum with handle
9 Water connection
10 Fine filter in the water connection
11 Coupling element for water connection
12 Spray lance with pressure regulation
(Vario Power)
13 Spray lance with dirt blaster
14 Washing brush
15 HP hose
16 Handgun with safety catch
17 Power cord with plug
18 Storage, power cord

Before Startup

Figures 1 -10
Attach the lose individual parts to your
high pressure cleaner.
Figure 11
Join HP hose and handgun together.
Push clip in until it engages and check
that it is securely fastened by pulling on
the HP hose.

Water supply

According to the applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
Water supply from mains
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
Use a fibre-reinforced hose (not included)
with a standard coupling:
- Minimum diameter, 1/2 inches (13 mm).
- Minimum length, 7.5 m.
Screw the coupling unit (supplied) to the
water connection on the appliance.
Push the water supply hose onto the
coupling unit, then connect it to the tap.
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the HP pump.
If the water supply is not clean, the Kärcher
water filter must be used (special accessory
- order No. 4.730-059).
Drawing in water from open reservoirs
When fitted with the appropriate accesso-
ries, this high-pressure cleaner can draw in
surface water, e.g. from water butts or
ponds (max. suction height 0.5 m).
As the standard coupling system is not
suitable for use in suction mode, the
Kärcher suction hose with integrated fil-
ter should be used instead (special ac-
13
English