Operating Controls - VOLTCRAFT LSG-10 Bedienungsanleitung

Operating Controls

(see fold-out page)
Receiver LSG-10
1 Sensor prod
2 LED torch
3 Display
4 Button "NCV" for switching between cable detection mode and contact-free AC voltage detection
5 Button for torch function (On/Off, off automatically after approx. 1 min.)
6 Down button for manual sensitivity settings
7 MODE buttons for toggling between automatic and manual mode
8 Button for switching the beep sound and display illumination on and off
9 Up button for manual sensitivity settings
10 Operating button (On/Off)
11 Battery compartment on the rear
Receiver display LSG-10
a Signal strength bar display
b Grid voltage indication
c Display for manual sensitivity selection
d Transmission code display
e. Signal level I, II or III display)
f Acoustic display is deactivated
g Signal strength display
h Sensitivity display (isolation symbols: many arches = low sensitivity; few arches = high sensitivity)
i Display for active display illumination
j Display for automated sensitivity selection
k Battery state display (4 bars = battery full; <1 bar = battery empty)
l Display for contact-free AC voltage detection
Transmitter LSG-10B
12 "Phase/+" connection socket
13 Connection socket reference potential (earth)
14 Display
15 Button for signal level settings (level I, II or III) and display illumination (press for 2s)
16 Operating button (On/Off)
17 Battery compartment on the rear
Transmitter display LSG-10B
m Voltage display !Display not suited for determination of lack of voltage!
n Transmission code display
o Signal level (I, II or III) display
p Battery replacement display
q Grid voltage indication
30