Single Face - Mounting With Bracket; Double Face - Mounting With Bracket - Gorgy Timing HANDI 300 Bedienungsanleitung

3.3.1. SINGLE FACE – MOUNTING WITH BRACKET
► The bracket can be fitted in the position
of wall mount or side mount.
► Fixation of the rod (2 screws of 6 x 16)
☛
Remark: Mount at 6h on request.
☛
This option shall be mentioned on
Purchase order. Screws are supplied with
every clock
3.3.2. DOUBLE FACE – MOUNTING WITH BRACKET
The bracket can be fitted in the position of
wall mount or side mount.
► Fix one rod on each clock face.
(4 screws of 6 x 16)
► Fix the 3 corner brackets on the back
panel of each face (6 self-tapping
screws of 4.8 x 19)
► Pass the cables through the rods
► Put the two clock sides back-to-back,
then assemble them by mounting the
connecting plates on each corner brac-
ket (self-tapping screws of 4.8 x 19)
► Fix the metal plate to the end of rod (6
screws of 5 x 20)
► Fix the circle strap onto the bracket (4
screws of 2.9 x 9)
☛
VSide mount: special attention shall be given to the fixation of rods
☛
Bottom Mount at 6h: on request. This option shall be mentioned on
MDE-HANDI-2078V2.2
(mount at 3h or 9h).
Purchase order.
☛
Screws are supplied with every clock.
Fig.1 – side mount
41