UNI-T MIE0146 Bedienungsanleitung Seite 20

Owner's manual
● Do not carry out the measurement when the Meter's back case and battery compart-
ment are not closed to avoid electric shock.
● Do not input higher than 600V between the Meter's terminals and the grounding to
avoid electric shock and damages to the Meter.
● When the Meter working at an effective voltage over 60V in DC or 30V rms in AC,
special care should be taken for there is danger of electric shock.
● Use the proper terminals, function, and range for your measurements.
● Do not use or store the Meter in an environment of high temperature, humidity,
explosive, inflammable and strong magnetic field. The performance of the Meter may
deteriorate after dampened.
● When using the test leads, keep your fingers behind the finger guards.
● Disconnect circuit power and discharge all high-voltage capacitors before testing
resistance, continuity and diode.
● Replace the battery as soon as the battery indicator appears. With a low battery, the
Meter might produce false readings that can lead to electric shock and personal injury.
● When servicing the Meter, use only the same model number or identical electrical
specifications replacement parts.
● The internal circuit of the Meter shall not be altered at will to avoid damage of the
Meter and any accident.
● Soft cloth and mild detergent should be used to clean the surface of the Meter when
servicing. No abrasive and solvent should be used to prevent the surface of the Meter
from corrosion, damage and accident.
● The Meter is suitable for indoor use.
● Turn the Meter off when it is not in use and take out the battery when not using for a
long time.
EN ● Constantly check the battery as it may leak when it has been using for some time, re-
place the battery as soon as leaking appears. A leaking battery will damage the Meter.
20