In Case Of Problems; Problems And Possible Causes - switel BCF 850 Bedienungsanleitung

7 In Case of Problems

Service hotline
Should problems arise with the equipment, please refer to the following information first. In the case of
technical problems, you can contact our hotline service, Tel. 0900 00 1675 within Switzerland (Swisscom
fees at time of going to print: CHF 2.60/min). In the case of claims under the terms of guarantee, contact
your sales outlet. There is a 2 year period of guarantee.

Problems and possible causes

Problem
Equipment cannot be switched on
The batteries have not been charged
Equipment does not work
Equipment "freezes"
Reception interference and noise
Beeping noise (acoustic feedback)
No image transmission
No image transmission, display is black
No image transmission, antenna icon
flashes in centre of display
No image transmission, message
appears in the centre of the display indic­
ating that no camera has been registered
Image transmission but no sound trans­
mission
Picture is in black and white
Possible causes and/or solutions
- The batteries are empty or defective.
- The On/Off button or On/Off / Back button was not
pressed long enough.
- The charging cable is not plugged in properly.
- The camera and/or monitor are not switched on.
- The batteries are empty or defective.
- If the problem persists, reset and restart the camera
and/or monitor.
- Reset and restart the camera and/or monitor.
- Other electronic devices are causing interference in the
field of transmission.
- The monitor and camera are too far apart.
- The battery power is too low.
- The monitor and camera are too close to each other.
- Increase the distance between the monitor and camera.
Reduce the volume on the monitor.
- Ensure that the batteries are sufficiently charged and
that the camera is registered on the monitor. If neces­
sary, switch to a camera already registered on a differ­
ent channel, refer to Page 71.
- Energy-save mode is active, refer to Page 73.
- The camera is not switched on.
- Register the camera.
- The volume is switched off or set too low.
- A lullaby is being played.
- On the monitor, all the image transmissions are dis­
played on screen, refer to Page 71.
- The night vision function is active.
In Case of Problems
75