switel BCF 850 Bedienungsanleitung Seite 68

Putting the Units into Operation
Putting the monitor into operation
Attention: Position the monitor unit with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Inserting and removing the battery
If you want to use the device to save video recordings on a microSD
card, insert the microSD card first, refer to Section "Inserting or remo­
ving a microSD card".
1. Pivot the stand away from the device.
2. Open the battery compartment on the rear side of the monitor: Slide the
battery compartment cover off.
3. Connect the battery plug to the connector in the housing, ensuring correct
polarity: the red cable to the positive pole, the black cable to the negative
pole.
4. Insert the battery. Pay attention that the cables are not kinked or under
strain.
5. Slide the battery compartment cover back on in the opposite direction until it
latches in place.
To remove the batteries, proceed in the reverse sequence.
Switch the monitor off before removing the battery.
Inserting or removing a microSD card
In order to save video recordings, you can insert a microSD card of max. 2 GB.
Switch the monitor off before inserting or removing a microSD card.
1. Switch the monitor off.
2. Remove the battery if one is installed.
3. To insert the microSD card, slide it in the microSD slot with the bare
contacts facing towards the device until it audibly snaps into place.
The correct end position of the microSD card
is indicated in white on the green board.
4. To remove the microSD card, press it slightly further into the device in the
direction it was inserted and then release it. The microSD card springs out
of the microSD card slot a little and can be removed.
5. Replace the battery in the device and close the battery compartment cover,
refer to Section "Inserting and removing the battery".
Charging the monitor
Connect the monitor unit as illustrated in the diagram.
Attention: Only use the charging cable
supplied for the monitor.
Charging of ther battery begins immediately the charging
cable is connected to the monitor unit and power outlet.
As soon as the battery is fully charged, the "Charging
process" LED lights up green.
To switch the monitor on, press and hold the
On/Off / Back button.
68
Mains power outlet