Memorizing A Sequence (Loop-Function) - Omnitronic DJS-1050 Bedienungsanleitung

turning forwards of the Scratch-wheel produces a playback resembling the playback-speed via the
Play/Pause-button. Press the In-button in order to memorize the Cue-point.

6.9 Memorizing a sequence (Loop-function)

With the Loop-function, you can repeat a programmable sequence. Please note that you can only recall this
sequence within one track. If you also wish to insert in other tracks, you need to memorize the sequence as
sample on one of the Bank-buttons.
Memorizing the Loop-points:
Possibility 1:
The player is in Playback-mode.
If the In-button is pressed in the playback-mode, the CD keeps running and the A-point (starting-point) is
marked. By pressing the Out-button, the B-point (end-point) of the sequence is marked.
The player repeats the sequence between A-point and B-point until you press the Out-button once more.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the A-point (starting-point) via the Scratch-wheel. The display shows the selected A-point (e.g. 3:42
22). Press the In-button and the selected A-point is marked.
Select the B-point (end-point) via the Scratch-wheel. The display shows the selected B-point (e.g. 3:51 11).
Press the Out-button and the selected B-point is marked.
The player repeats the sequence between A-point and B-point until you press the Out-button once more.
You can repeat the sequence once more if you press the Reloop-button.
6.10 Sampler-mode
Set the Loop In-point and Loop Out-point like described above. If a sample is to be memorized on a Bank-
button, only the first 5 seconds will be memorized.
Memorizing several samples:
With the DJS-1050, you can memorize up to 4 different samples of different tracks and recall them via the
Bank-button.
Hold the Sampler/Memory-button and press the desired Bank-button in order to memorize the current
sample on the Bank-button.
The memorized samples can be overwritten at any time. Please note that the samples can only be deleted
by switching the CD-player off an on again.
You can recall all memorized samples from up to 127 CDs after switching the CD-player off. Therefore, you
have to switch the CD-player on, hold the Sampler/Memory-button and insert the respective CD. The display
shows "Recall" until the loading process is finished.
Playback of memorized samples:
Continuous-mode:
By pressing the Sampler/Memory-button (LED on) and the respective Bank-button, you can recall the
samples memorized via the Sampler/Memory -button. The sample will be repeated until you press the
Sampler/Memory-button again (LED off).
The memorized samples can be played back at any time. If the Sampler/Memory-button is pressed during
the playback of the CD, the sample mixes with the CD-playback. If the Sampler/Memory-button is pressed in
the Pause-mode, the sample alone is being played back. The sample playback-speed can temporarily be
adjusted via the Pitch Bend-buttons.
One-shot-mode:
Press the Sampler/Memory-button until the LED flashes. The current sample is stopped and the player goes
into one-shot-mode. When you press the desired Bank-button now, the sample is only played once.
Press the Sampler/Memory-button again (LED off) in order to leave this mode.
Using temporary samples
The temporary samples on the Bank-buttons remain in the buffer memory if you change the CD without
switching the CD-player off. Please note that these samples are only temporarily available and cannot be
27/55 10602297_V_1_0.DOC