Rear Panel - Omnitronic DJS-1050 Bedienungsanleitung

17. TIME-BUTTON
The display can be switched from track remain time (Remain) to total remain time (total remain) or track
playback time (Elapsed).
18. SGL/CTN-BUTTON
For choosing single playback or continous play. By pressing this button once, the display shows „SINGLE".
The current track is then played once and the player goes into Pause-mode at the next track-start.
19. PITCH BEND-BUTTONS
With the Pitch Bend-buttons, you can adjust the playback-speed temporarily by up to +/- 100 %. Please refer
to 6.6 Adjusting the playback-speed.
If you press and hold the Pitch Bend - button, the playback speed decreases down to 0. This effect is
comparable with the Motor Off-effect.
20. SCRATCH-WHEEL
Playback-mode:
Via the Scratch-wheel, you can adjust the playback-speed by +/- 100 %. Please refer to the explanations
under 6.6 Adjusting the playback-speed.
Pause-mode:
In the pause-mode, the current frame is repeated as soon as you turn the Scratch-wheel.
Via the Scratch-wheel, you can slowly search within a title forwards and backwards. In this way, you can
easily find a Cue-point for example.Turn the Scratch-wheel to the right in order to search forwards and turn it
to the right in order to search backwards. The faster you turn the Scratch -wheel the higher the searching-
speed. Please refer to the explanations under 6.7 Cueing.
Vinyl Cue-function:
If you press the Scratch-button, you can activate the VINYL CUE-function. This function disables the frame-
function of the CD-player and you can search for the Cue-point as with a turntable. Please refer to the
explanations under 6.8 Interactive scratch-wheel.
4.3 Rearpanel
21 22 23 24 25
21. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
22. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
23. RELAY-SOCKET
To connect a mixer or CD-player.
24. POWER SWITCH
Press this button to start operation.
23/55 10602297_V_1_0.DOC