Omnitronic DJS-1050 Bedienungsanleitung Seite 22

5. LOOP OUT-BUTTON
By pressing the Out-button, you can memorize the Loop Out-button. The player will repeat the memorized
sequence until you press the Out-button once more.
6. RELOOP-BUTTON
Via the RELOOP-button, you can call up a memorized sequence once more.
7. CUE-BUTTON
Pause-mode:
In the pause-mode, you can cue by pressing and holding the Cue-button. As soon as you let the Cue-button
loose, the player returns to the track-start or the Cue-point.
Playback-mode:
If you press the Cue-button during playback, the player returns to the track-start or the Cue-point and goes
into Pause-mode.
On the Cue-button, you can memorize the fourth Cue-point.
Please refer to the explanations under 6.7 Cueing.
8. PLAY/PAUSE-BUTTON
With the Play/Pause-button, you can start the playback and stop it again. Please refer to the explanations
under 6.4 Play/Pause.
9. SCRATCH/VINYL CUE-BUTTON
With the Scratch-button, you can activate the Scratch-function. Please refer to the explanations under 6.8
Interactive scratch-wheel.
10. SAMPLER/MEMORY-BUTTON
SAMPLER:
By pressing the Sampler/Memory-button (LED on), you can recall a sample you memorized on one of the
Bank-buttons before. You can select between Continuous-mode and One-shot-mode.
The memorized samples of a CD remain in the memory until you switch off the CD-player or overrite the
samples.
You can recall all memorized Cue-points and samples from up to 127 CDs by switching the CD-player on,
holding the Sampler/Memory-button and inserting the respective CD.
Please refer to the explanations under 6.10 Sampler-mode.
MEMORY:
With this button, you can memorize the current Cue-point or the current sample via one of the four Bank-
buttons. Hold the Sampler/Memory-button and press the desired Bank-button. Please refer to the
explanations under 6.7 Cueing and 6.10 Sampler-mode.
You can memorize up to 4 Cue-points and samples and recall them via the respective Bank-button.
Please note that the maximum sample-length is 5 seconds.
You can recall all memorized Cue-points and samples from up to 127 CDs by switching the CD-player on,
holding the Sampler/Memory-button and inserting the respective CD.
11. EJECT BUTTON
Via the EJECT-button, you can open and close the CD-tray. Please refer to the explanations under 6.2 CD
tray.
12. MAIN TEMPO-BUTTON
With the MAIN TEMPO-button, you can adjust the pitch of an adjusted playback speed. Press the MAIN
TEMPO-button in order to adjust the pitch.
13. PITCH ON/OFF-BUTTON
With this button, you can switch the speed-adjustment via the pitchfader off (LED off). Please refer to 6.6
Adjusting the playback-speed.
14. 4/8/16/100%-BUTTONS
With these buttons, you can select the speed-adjusting range between +/- 4 %, +/- 8 %, +/- 16 % or
+/- 100 %. Please refer to 6.6 Adjusting the playback-speed.
16. PITCHFADER
You can adjust the desired speed with the Pitchfader. The display shows the current percentage.
22/55 10602297_V_1_0.DOC