Stihl SE 61 Gebrauchsanleitung Seite 24

English
During work
If the power cord is dam-
aged, unplug it
immediately – danger of
electrocution!
Ensure that the power cord is not
damaged by being driven over,
squashed or pulled, etc.
Never unplug the power plug by pulling
on the cord: always grip the plug itself.
The power cord and power plug must
never be touched with wet hands.
Never spray electrical devices with
water – Danger of short-circuiting!
In the event of imminent danger or in an
emergency – move switch to 0 .
Never let the machine run unattended.
Do not leave the machine standing in the
rain.
The machine may only be operated in an
upright position. Do not cover the
machine and ensure adequate motor
ventilation.
Ensure that the filter element is always
undamaged.
If foam develops or liquid escapes, stop
work immediately, unplug the power
cord, and empty the container.
If the machine is subjected to unusually
high loads for which it was not designed
(e.g., heavy impact or a fall), always
check that it is in good condition before
continuing work - refer also to the
chapter "Before starting work". Also
make certain that the safety
mechanisms are working properly.
22
Never continue using a machine that is
not in perfect working order. Consult a
servicing dealer if in doubt.
Before leaving the machine: Switch off
the machine – unplug the power cord.
After finishing work
Unplug the power plug from the socket
Never unplug the power plug by pulling
on the cord: always grip the plug itself.
Clean the machine to remove dust and
dirt – do not use degreasing agents.
Maintenance and Repairs
Before carrying out any
work on the power tool:
Disconnect the plug from
the power supply.
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
Only use high-quality replacement parts
in order to avoid the risk of accidents
and damage to the machine. If you have
any questions in this respect, consult a
servicing dealer.
STIHL recommends the use of genuine
STIHL replacement parts. These parts
are specifically designed to match your
machine model and meet your
performance requirements.
To reduce the risk of serious injury, have
repairs to the unit (e.g. replacing the
power supply cord) performed by an
authorized electrician.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
Clean cooling air inlets in motor housing
as necessary.
SE 61, SE 61 E