SATA SATAjet 4800 K spray mix Betriebsanleitung Seite 152

Operating instructions SATAjet 4800 K spray mix
EN
The material nozzle geometry defines the spray fan pattern width and the
spraying angle. The spray fan pattern can be adjusted by adding more
compressed air at the air cap.
■ A round fan can be set by rotating the round and flat fan control
(B) [5-1].
■ The air flow can be regulated via the air micrometer [5-2].
Painting
Notice!
When painting, only use as much material as is required for the specific
procedure.
When painting, maintain the necessary spray distance. After painting,
store or dispose of the material correctly.
■ Heed the necessary spray distance.
■ Ensure there is sufficient spraying air feed and material supply.
■ Release the spray gun with the trigger lock [6-1] on the trigger
guard [6-2].
■ Completely remove the trigger guard for spraying [7-1].
■ Move the spray gun as shown in [7-2].
End the spraying process
■ Secure the spray gun with the trigger lock [6-1] on the trigger
guard [6-2].
■ If painting has finished or a longer painting pause is planned, discon-
nect the spraying air and the material supply and heed the instructions
for care and storage (see chapter 11).
152