Operation; Fitting And Filling The Blender - Silvercrest SSML 1000 A1 Bedienungsanleitung

Operation

WARNING!
► The motor switches itself off as soon as the blender
motor block
is still switched on. The motor will then start unexpectedly as soon as the
blender
Therefore:
–
Do not insert the power plug into the wall socket until the blender
filled and mounted with its lid fitted and closed.
–
Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
–
Before removing the blender
power plug and wait for the motor to stop turning.
Fitting and filling the blender
1) Rotate the blender
handle is located above the
motor block
2) Remove the lid
until you can pull it upwards.
3) Fill the blender
4) Press the lid
it clockwise to position
pouring spout on the blender
Fig. 1
5) Place the measuring cap
it clockwise.
SSML 1000 A1
. It is thus possible to overlook the fact that the appliance
is replaced on it:
anticlockwise until the arrow
position. Remove the blender
in a vertical, upward motion.
by rotating it anticlockwise towards position
.
firmly down onto the blender
until it audibly engages (see Fig. 2). Ensure that the
is closed.
in the opening in the lid and close it by turning
is removed from the
, switch the appliance off, remove the
under the blender
. Close the lid
Fig. 2
GB │ IE │ NI │ CY
is
from the
(see Fig 1)
by turning
│ 7 ■