Quick MILL 0998 Gebrauchsanweisung Seite 13

Mod. 0998 2GR. Uragano Compact
POWER SUPPLY
HEATING ELEMENT POWER
SUPPLY
HEATING ELEMENT POWER
BOILER
Width (W)
Depth (D)
Height (H)
Net weight
INTRODUCTION
Keep this instruction manual in a safe place; for any
information or problems not comprehensively dealt with,
contact qualified personnel.
1. SYMBOLS
The warning triangle identifies all
explanations of importance for human
safety.
Follow these indications to prevent accidents!
The numerical symbol, numbers or letters
2
indicates references to illustrations and parts of
the machine like buttons, luminous indicators,
etc.
This product
requirements
Directive (2002/96/EC). The affixed symbol
indicates that this electrical or electronic
product should not be thrown in a container for
household waste. PRODUCT
references to the types of appliances listed in Annex 1 of
the WEEE Directive; this product falls into category 2
"Small household appliances".
DO NOT THROW INTO A CONTAINER FOR
HOUSEHOLD WASTE.
The manufacturer assumes no responsibility
for possible damage or injury to objects or
persons in case of:

• Uses not in conformity with the intended purposes;

Damage caused by improper use;
 • Alteration to the power cord;
 • Alteration to any machine part;
 • Use of non-original components or accessories;
 • Repairs not made at authorised service centres;
Lack of compliance with the above points render the
warranty invalid.
2. WARNINGS

Do not leave packaging items (plastic bags,
expanded polystyrene, nails, cardboard boxes, etc.)
within the reach of children as they are potentially
hazardous.

Before connecting the machine make sure that the
rating plate data comply with those of the power
distribution network.
V / Hz
V
W
Lt (oz)
mm (in)
mm (in)
mm (in)
Kg (lb)
complies with the
established in the WEEE
CATEGORY
2 UNITS
220-230
230 V
2700
7.5
740 (29.13)
530 (20.86)
530 (20.86)
57 (125.66)

The power cord should be completely extended (do
not roll up or overlap) and positioned where it is not
exposed to bumps or minor tampering; do not place
near water or other liquids or near heat sources;
make sure it is not damaged (otherwise have it
replaced by qualified personnel).

The use of adapters, multiple outlets and/or
extension cords is not recommended. If it should be
necessary to use them, use products with quality
certification marks (e.g. IMQ, VDE, +s, etc.) and
make sure that the stamped power value is in any
case higher than the absorption (A = ampere) of the
connected appliances.

In case of doubt or uncertainty, have the power
supply system checked by qualified personnel; it
must comply with the requirements set out by the
current safety standards, including:
label
o effective earthing;
o cross section of conductors sufficient for the
absorption power;
o efficient cut-out device.

with
Place the machine on a water-resistant surface
(laminate, steel, ceramic, etc.) away from heat
sources (ovens, burners, fireplaces or chimneys,
etc.) and in locations where the temperature does
not go below 5°C.

Do not expose the machine to inclement weather or
install it in rooms with high humidity like
bathrooms.

If you have to replace parts, contact a dealer or
authorised reseller and only use original spare parts.

Store the packed machine in a place sheltered from
inclement weather that is dry and moisture free. The
temperature should not be below +5°C.

A maximum of four packages of the same type may
be stacked. Do not set heavy packages of another
type on top of the package.
The manufacturer cannot be held responsible
for any damage/injuries to objects or persons
caused by incorrect installation or use.
3. DESCRIPTION
3.1 Features
Rev. 00