Repair And Maintenance; Warranty - Eaton zeb XTOE Handbuch

2 Engineering

2.6 Repair and Maintenance

2.6 Repair and Maintenance

2.7 Warranty

38
The ZEB overload relays shall undergo proof test during regular maintenance
operation at least every 1 year. The proof test procedure is explained under
the installation and operation section of this manual.
If the device observed to be failed in maintenance check it shall be taken out
of operation and return to Eaton Corporation.
￫
This could ether be done via the local contact person
http://www.eaton.de/EN/EatonDE/ProdukteundLoesungen/Electrical/
Kundensupport/AfterSalesSupport/AfterSalesSupport/index.htm
or under the following number: +49(0)1805223822
CAUTION

Faulty devices shall not be opened or repaired.
They must be replaced by specialist personnel.
To meet the conditions of the warranty, you must oberserve the safety and
commissioning instructions and the operating instructions.
If the overload relay found to be non operational within the warranty period or
after the warranty period it should be returned to Eaton Corporation.
￫
This could ether be done via the local contact person
http://www.eaton.de/EN/EatonDE/ProdukteundLoesungen/Electrical/
Kundensupport/AfterSalesSupport/AfterSalesSupport/index.htm
or under the following number: +49(0)1805223822
ZEB (XTOE, C440) 11/16 MN03402007Z-DE/EN www.eaton.com