Specifications; Standard Accessories - Hitachi DH 24PD2 Bedienungsanleitung

English

SPECIFICATIONS

Voltage (by areas)*
Power Input
No-load speed
Full-load impact rate
Capacity: concrete
steel
wood
Weight (without cord and side handle)
Dust collecting adapter
Max. hole-drilling depth:
Diameter of drill:
Max. length of drill (overall length):
Dustbag capacity:
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case (Molded plastic) ................................................. 1
(2) Side handle ................................................................. 1
(3) Dust collecting adapter .............................................. 1
(4) Dust bag ...................................................................... 1
OPTIONAL ACCESSORIES (sold separately)
1. Drilling anchor holes (rotation + hammering)
Drill bit (Slender shaft)
Drill bit (Slender shaft)
Outer diameter
3.4 mm
3.5 mm
Drill bit (Taper shank) and taper shank adapter
Drill bit (Taper shank)
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
7
Adapter for slender shaft
(SDS-plus shank)
Drill bit (slender shaft)
Effective length
45 mm
Taper shank adapter
(SDS-plus shank)
Cotter
Taper mode
Morse taper (No.1)
Morse taper (No.2)
A-taper
B-taper
(110V, 230V)
720W*
0 – 1050 min
0 – 4600 min
3.4 – 24 mm
13 mm
32 mm
100 mm (adjustment possible between 0 and 100 mm)
3.4 – 24 mm
270 mm
0.4 liters
[Numbers (3) and (4) refer to use on concrete]
(5) Cap ............................................................................... 1
Standard accessories are subject to change without
notice.
Overall length
90 mm
Drill bit (taper shank)
Drill bit (taper shank)
Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
drill bit for it is not provided.
–1
–1
2.8 kg
Applicable drill bit
11.0 ~ 17.5 mm
21.5 mm