Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
_________________________________________________________________________________________
2
General safety instructions
2.1 Intended use
The clamping device may only be used in accordance with the technical data. The clamping
device has been designed for stationary application on milling machines in an industrial
environment.
Using the device in accordance with the intended purpose includes compliance with the
commissioning, installation and operating instructions, and with the environmental and
service conditions as provided by the manufacturer.
Using the device outside of the above parameters is deemed non-intended use.
The manufacturer accepts no liability for damage resulting from non-intended use.
2.1.1 Technical data
Type
max. torque
KSO 40
20 Nm
Optimum working range:
Clamping force:
Torque:
Exposure to loads in excess of the maximum pull-in torque results in damage
to the spindle.
Weight:
solinos 40:
For further data, please see the current catalogue >> Schunk stationary Workholding <<
2.2 Reasonably forseeable misapplication
Any application that is not in accordance with the "Intended use" or exceeds
such intended use is considered not in accordance with the regulations, and is forbidden.
Any other use of the device is subject to confirmation from the manufacturer.
Examples of forseeable misapplication:
Clamping device used on rotating systems.
Clamping widely protruding workpieces.
Clamping workpieces with a weight of over 20 kg in vertical position
without an additional safeguard to prevent the item falling out.
2.2.1 Alterations and modifications
In the case of unauthorised alterations and modifications of the clamping device, the
manufacturer's liability ceases and any warranty is voided.
www.schunk.de
max. clamping
force
12 kN
12 kN
20 Nm
1.7kg
Nm
30
25
20
15
10
5
0
0
XND.00014.008_A - 08/2016
Anzugsmoment / Spannkraft
2
4
6
8
10
12
14
16
kN
15
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
