What To Do If - IKEA TINAD Bedienungsanleitung

ENGLISH

What to do if...

Problem
The control panel is
switched off, the appliance
does not work.
The inside light does not
work.
The inside light flashes.
The temperature inside the
compartments is not low
enough.
There is water on the
bottom of the refrigerator
compartment.
Excessive amount of
frost in the freezer
compartment.
Possible causes:
There may be an
appliance power supply
problem.
The appliance could be in
On/Stand by mode.
The light may need
replacing.
Malfunction of a technical
component.
Door alarm active.
It is activated when the
refrigerator compartment
door remains open for a
prolonged period of time.
There could be various
causes (see "Solutions").
The defrost water drain is
blocked.
The door to the freezer
compartment is not
closed properly.
Solutions:
Check that:
• there is not a power outage;
• the plug is properly inserted
in the socket and any bipolar
power switch is in the correct
position (this enables the power
supply to the appliance);
• the household electrical system
protection devices are efficient;
• the power cable is not broken.
Turn the appliance on by briefly
pressing the button
(see On/Stand-by function).
Disconnect the appliance from
the power supply and contact
the Technical Assistance Service
if you need a replacement.
To stop the alarm, close the
refrigerator door.
On reopening the door, check
the light works.
Check that:
• the doors close properly;
• the appliance is not installed
near a heat source;
• the set temperature is
adequate;
• the circulation of air through
the vents at the bottom of the
appliance is not obstructed (see
installation section).
Clean the defrosting water drain
(see section "Cleaning and
Maintenance"
Check that there is nothing
preventing the door from closing
properly.
• Defrost the freezer
compartment.
• Make sure the appliance has
been correctly installed.
1 1