Daily Use - IKEA TINAD Bedienungsanleitung

ENGLISH

Daily use

Refrigerator and freezer operation
The appliance's refrigerator compartment
features a control panel with LED lights. A
different temperature can be set using the
C
button as shown in the figure.
The three green LED indicators indicate the
refrigerator compartment set temperature.
The following adjustments are possible:
Leds on Set temperature
High (least cold)
Medium-high
Intermediate
Medium-low
Low (coldest)
Stand-by
C
Press the button for 3 seconds to
deactivate the appliance (the control panel
and lights remain off). Press the button
again briefly to reactivate the appliance.
Note: This operation does not disconnect
the appliance from the power supply.
Note: the ambient temperature, frequency
of door opening and position of the
appliance can affect the temperature inside
the two compartments.
These factors must be taken into account
when setting the thermostat.
A
A
Led light
B
Refrigerator compartment temperature
C
Button for temperature regulation and
Stand-by function
B C
LED light
LEDs last longer than traditional light
bulbs, improve internal visibility and are
environmentally friendly.
Contact the Service Centre if replacement is
necessary.
Fan
The fan is pre-set to ON. You can turn the
fan on/off by pressing the light button (as
shown in figure 2) and at the same time the
button as shown in figure 3.
The light will flash just once if the fan is OFF,
or it will flash 3 times if the fan in ON. If
the ambient temperature exceeds 27°C, or
if drops of water are present on the glass
shelves, it is essential to have the fan on to
ensure the proper preservation of the
food. Deactivation of the fan allows energy
consumption to be optimised.
1 2
Fast Cooling function (Fast Cooling)
To quickly cool the refrigerator
compartment, or 6 hours before putting a
large quantity of food to be frozen in the
freezer compartment, turn on the "Fast
Cooling" function by repeatedly pressing
the button until the 3 icons flash green and
then stay constant.
The function automatically turns off after 30
hours and the temperature returns to the
previous setting when the function is turned
on.
8
3