What To Do If - IKEA FRYSA AA-2242711-2 Bedienungsanleitung

ENGLISH

What to do if ...

Problem
The control panel is switched off, the
appliance does not work.
The internal light does not work.
The temperature inside the compartment is not
cold enough.
The front edge of the appliance, at the door
striker seal, is hot.
F
The red icon is flashing and a sound signal
is activated
F
The red icon will light up, a sound signal is
activated and the letter "F" is flashing on the
display.
The Temperature display blinks (°C) and
the Alarm Indicator remains on.
E
The Black Out Alarm icon remains on,
F
the Alarm indicator blinks and the
Temperature display (°C) blinks, showing
the maximum temperature reached
during blackout.
Before contacting the After-sales service:
Switch the appliance on again to see if the problem has
disappeared. If not, switch it off again and repeat the operation
after an hour.
If your appliance still does not work properly after carrying out
the checks listed in the troubleshooting guide and switching
the appliance on again, contact the After-sales service, clearly
explaining the problem and specifying:
• the type of fault;
• the model;
Possible causes:
The appliance may be in On/Stand-by mode.
There may be an appliance power supply
problem.
The light may need replacing.
The appliance may be in On/Stand-by mode
There could be various causes (see "Solutions")
This is not a defect. It prevents condensation
from forming.
Door open alarm
It is activated when the door remains open for
a prolonged period of time.
Malfunction alarm
The alarm indicates the malfunction of a
technical component.
Temperature alarm
The inside temperature is not adequate.
Long Black-Out alarm
Prolonged power failure, able to cause the
inside temperature to increase to 0°C.
Note:
Gurgling, hissing and humming noises from the refrigerating system are normal.
•
•
Solutions:
Turn the appliance on pressing the On/
Stand-by button. Make sure:
- there is not a power outage
- the plug is properly inserted in the power
socket and the mains double-pole switch
(if present) is in the correct position (i.e.
allows the appliance to be powered)
- the household electrical system
protection devices are efficient
- the power cable is not broken.
- Contact the authorised Technical
Assistance Service.
- Turn the appliance on pressing the On/
Stand-by button
Make sure:
- the door close properly
- the appliance is not installed near a heat
source
- the set temperature is adequate
- the circulation of air through the
ventilation grilles on the base of the
appliance is not obstructed.
No solution is necessary.
To turn the sound signal off, close the door
of the product.
Call the authorized Technical Assistance
Service. To turn the sound signal off,
briefly press the "Turn off sound alarm"
F
.
Press the Stop Alarm button
acoustical alarm stops, the Temperature
Display (°C) blinks and the Alarm Indicator
F
remains on until a temperature <-10°C
is reached.
Press the Stop Alarm button
acoustical alarm stops, the Temperature
Display (°C) blinks
and the Alarm Indicator
until a temperature <-10°C is reached.
the type and serial number of the appliance (given on the
rating plate);
the Service number (the number after the word SERVICE on
the rating plate inside the appliance).
11
F
; the
F
; the
F
remains on