Electromagnetic Compatibility Information - Beurer BC 20 Gebrauchsanleitung

Electromagnetic Compatibility Information

Guidance and manufacturer's declaration – electromagnetic emissions – for all EQUIPMENT and SYSTEMS
Guidance and manufacturer's declaration – electromagnetic emission
The BC 20 Blood Pressure Monitor is intended for use in the electromagnetic environment specifi ed below. The customer of the user of
the BC 20 Blood Pressure Monitor should assure that it is used in such and environment.
Emissions test
RF emissions CISPR 11
RF emission CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fl uctuations/fl icker emissions
IEC 61000-3-3
Guidance and manufacture's declaration – electromagnetic immunity – for all EQUIPMENT and SYSTEMS
Guidance and manufacture's declaration – electromagnetic immunity
The BC 20 Blood Pressure Monitor is intended for use in the electromagnetic environment specifi ed below. The customer or the user of
BC 20 Blood Pressure Monitor should assure that it is used in such an environment.
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Power frequency (50/60Hz)
magnetic fi eld IEC61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
Compliance Electromagnetic environment – guidance
Group 1 The BC 20 Blood Pressure Monitor uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause any interfe-
rence in nearby electronic equipment.
Class B The BC 20 Blood Pressure Monitor is suitable for use in all establishments,
including domestic establishments and those directly connected to the public
N/A
low-voltage power supply network that supplies buildings used for domestic
N/A
purposes.
IEC 60601 test level Compliance level
± 6 kV contact ± 6 kV contact
± 8 kV air ± 8 kV air
3 A/m 3 A/m
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile. If fl oor are
covered with synthetic material, the relative humidity should
be at least 30 %.
Power frequency magnetic fi elds Should be at levels charac-
teristic of a typical location in a typical commercial or hospi-
tal environment.
65