Further Safety Directions - Parkside PDSSE 450 B2 Originalbetriebsanleitung

GB
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the
power source and/or the bat-
tery pack from the power tool
before making any adjust
-ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly main-
tained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
8
h) Hold the device by the insulated
gripping surfaces when per-
forming work in which the cut-
ting tool may come into contact
with hidden wiring or its own
cord. Contact with a live wire can also
cause a charge in metal parts of the
device and result in an electric shock.
h) Keep handles dry, clean and
free from oil and grease. Slippery
handles and handle surfaces do not
permit safe operation and control over
the power tool in unexpected situa-
tions.
5) SERVICE
Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.

Further safety directions

a) Hold the power tool by the
insulated handle grips when
performing work in which the
screw may come into contact
with hidden wiring or its own
power cord. If the screw were to
come into contact with a live electrical
cable, metal parts of the appliance
could also become live and cause an
electric shock.
b) Keep hands away from rotating
parts. Wait until the power tool
has stopped before placing it
down. Risk of injury!
c) Avoid contact with the tool
insert or the component part
immediately after processing.
The parts may be hot and cause burn
injuries.