Specifications - Makita AN250HC Betriebsanleitung

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency
5. Adjuster
6. Too deep
7. Flush
8. Too shallow
9. Screw
10. Hook

SPECIFICATIONS

Min. hose diameter
Dimensions (L X W X H)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
...... Wear safety glasses.
Intended use
The tool is intended for securing a thin steel plate to the
concrete.
Pneumatic nailer/stapler safety
warnings
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Save all warnings and instructions for
future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
General safety
• Do not permit those uninstructed to use the tool.
• No horseplay. Respect the tool as a working
implement.
6
Explanation of general view
11. Contact element
12. Nose adapter
13. LOCK position
14. FREE position
15. Latch lever
16. Door
17. Driver channel
18. Trigger
19. Workpiece
20. Thin steel plate
Model
Air pressure
Nail length
Nail capacity
Net weight
• Do not operate when under the influence of alcohol,
END105-3
drugs or the like.
• Never alter the tool.
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
the tool operators and by other persons in the
immediate working area.
ENE072-1
For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
glasses and the face shield should conform with the
requirements of AS/NZS 1336. (Fig. 1)
ENB110-4 • Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate the tool in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust.
Operating the tool can create sparks which may ignite
the dust or fumes.
• Keep children and bystanders away while operating the
tool. Distractions can cause you to lose control.
• Illuminate the work area sufficiently.
• There may be local regulations concerning noise which
must be complied with by keeping noise levels within
21. Penetration amount into concrete
22. Cap
23. Drain cock
24. Air filter
25. Oiler
26. Pneumatic oil
27. Thinner
28. Stove
AN250HC
1.18 - 2.26 MPa (11.8 - 22.6 bar)
19 mm - 25 mm
Sheet-collated coil pin
100 pcs
5 mm
295 mm X 128 mm X 291 mm
2.1 kg