Installation Instructions; Water Connection - clage MBH 6 Gebrauchs- Und Montageanleitung

Installation

3.2 Installation instructions

The heater is installed directly to the connecting pipes of the tap. We guarantee trouble-free
operation of the instantaneous water heater only if CLAGE fittings and accessories are used.
Note the following during installation:
• Installation must comply with DIN VDE 0100 and DIN 1988 or EN 806-2 and with the stat-
utory regulations of the country and the provisions of the local electricity and water supply
company.
• Check the technical data and information on the rating plate.
• Easy access to the instantaneous water heater must be guaranteed at all times for mainte-
nance purposes. An separate shut-off valve must be installed.
• Ensure that all accessories are removed from the packaging.
• When using the supplied flexible connecting hose, the minimum bending radius of 27mm
must be observed at all times. The connecting hose must not be subjected to any tensile or
compressive effects during assembly and when in use.

3.3 Water connection

1. Position the instantaneous water heater with the water connectors vertically upwards for
direct connection to the tap.
2. Secure the wall bracket to the wall with suitable screws and dowels.
3. Place the appliance onto the wall bracket and snap it into position. Only use the appliance
if it is fitted correctly to the wall bracket.
Fig. 5: "Installing the wall bracket"
25
EN