Programming; Operating Test; End-Users Training; Connecting Peripherals - Somfy Dexxo Pro Rts Installationsanleitung

Dexxo Pro RTS
Do not tighten the mounting screw all the way down. Excessive
tightening can damage the screw and cause the travel stop not to
remain in place.
Fitting the chain retainer pads (Fig. 13)
For chain rails only.
Make sure that the pad is pressed in all the way so that its positioning pin is
Checking the chain or belt tension (Fig. 14)
tensioning.
The rubber or tension spring must never be fully compressed during
operation.
Connecting the mains power supply (Fig. 15)
[1].
[2]. Connect to the mains supply.
Plug the power cable into a suitable power outlet that complies with
electric power requirements.

4 - PROGRAMMING

4.1 Programming button description
Buttons Function
-
-
-
-
-
- Stop learning
- Selecting a setting
-
-
- Start the learning cycle
-
-
4.2 End limit setting and self-learning - Fig. 16
For swinging doors, change the P9 setting before starting self-learning.
[1]. SET
S2
[2]. Control the motor using the "+" or "-" buttons so that the transmission
system runner moves to link up with the trolley and closes the door.
-
Release the "-" button before the motor has time to force against the
door.
- Pressing and holding the "+" button opens the door.
[3]. Adjust the closed position using the "+" or "-" buttons.
Release the "-" button before the motor has time to force against the
door.
[4]. OK
learning cycle.
The door runs through a complete Open Close cycle.
-
-
S1
-
interrupt the learning mode.
-
At the end of installation, it must be checked that the obstacle detection
complies with annex A of the standard EN 12 453.
4.3 Memorising the remote controls for operation in
«Total opening» mode - Fig. 17
At this stage in the installation process, the Dexxo Pro motor drive unit is
ready to run.

5 - OPERATING TEST

5.1 Using the remote controls - Fig. 18
5.2 Obstacle detection function - Fig. 19 et 20
Make sure that obstacle detection works when the door encounters an obstacle
5.3 Built in lighting operation
The light will come on every time the motor drive unit is operated. It will go out
protection.

5.4 End-users training

compulsery checks.

6 - CONNECTING PERIPHERALS

6.1 Description of the various peripherals - Fig. 21
Key. Description
1 Orange light
2
Code keypad
Keyswitch
Aerial
Battery
7
Photoelectric cells
10 Sensor bar
11 Siren
C1
SET
C1
WARNING
Fig. 19).
EN
Fig. 20).