Use Of The Appliance; Setting The Water Softener - Electrolux ESI63010 Benutzerinformation

USE OF THE APPLIANCE

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.

SETTING THE WATER SOFTENER

The water softener removes minerals and
salts from the water supply. Minerals and
salts can have bad effect on the operation
of the appliance.
Water hardness is measured in equivalent
scales:
• German degrees (dH°).
Water hardness
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.
mmol/l Clarke
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
5. Set the correct washing programme for
the type of load and soil.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the
chapter 'Use of detergent'.
• French degrees (°TH).
• mmol/l (millimol per litre - international
unit for the hardness of water).
• Clarke.
Adjust the water softener to the water hard-
ness in your area. If necessary, contact
your local water authority.
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1)
1
5. Close the door.
Electronic adjustment
The water softener is set at the factory
at level 5.
electrolux 37
electronically
10
9
8
7
6
5
4
3
2
1)
1