Herunterladen Inhalt Inhalt Diese Seite drucken

Setting And Starting A Washing Programme - Electrolux ESI63010 Benutzerinformation

Halbintegrierter geschirrspüler
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

42 electrolux
B
4. If you use detergent tablets, put the de-
tergent tablet in the detergent dispenser
(A).
5. Close the lid of the detergent dispenser.
Press the lid until it locks into position.
Different brands of detergent dissolve
in different times. Some detergent tab-

SETTING AND STARTING A WASHING PROGRAMME

Do these steps to set and start a washing
programme:
1. Close the door.
2. Turn the programme knob to set the
washing programme. Refer to the chap-
ter 'Washing programmes'.
– The on/off indicator light comes on.
– The phase indicator light for the wash-
ing programme starts to flash.
3. Press the start/cancel button.
– The washing programme starts auto-
matically.
A
lets do not have the best cleaning re-
sults during short washing pro-
grammes. Use long washing pro-
grammes when you use detergent tab-
lets to fully remove the detergent.
Use of combi detergent tablets
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents
When you use tablets, that contain special
salt and rinse aid, it is not necessary to fill
the salt and rinse aid containers. In this con-
dition the rinse aid indicator light stays on
when the appliance is switched on.
1. Do a check if these tablets are applica-
ble for the local water hardness. Refer
to the instructions from the manufacturer.
2. Select the lowest setting for the water
hardness and rinse aid dosage.
Do these steps if the drying results are not
satisfactory
1. Fill the rinse aid dispenser with rinse aid.
2. Set the rinse aid dosage to position 2.
To use normal detergent again
1. Fill the salt container and rinse aid dis-
penser.
2. Adjust the water hardness setting to the
highest level.
3. Do a washing programme without
dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the rinse aid dosage.
– The start/cancel indicator light comes
on.
– When the programme starts, only the
phase in progress indicator light stays
on.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis