Use Of Dishwasher Salt; Use Of Rinse Aid - Electrolux ESI63010 Benutzerinformation

38 electrolux
1. Press and hold the start/cancel button.
Turn the programme knob clockwise un-
til the programme marker agrees with
the first washing programme on the con-
trol panel.
2. Release the start/cancel button when
the on/off indicator light and the start/
cancel indicator light start to flash.
– At the same time, the end indicator
light flashes to show the level of the
water softener.

USE OF DISHWASHER SALT

Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the
water softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
3. Use the funnel to fill the salt container
with salt.

USE OF RINSE AID

Caution! Only use branded rinse aid
for dishwashers.
Do not fill the rinse aid dispenser with
other products (e.g. dishwasher clean-
Example:
5 flashes, pause, 5 flashes, pause,
etc... = level 5
3. Press the start/cancel button one time
to increase the water softener level by
one step.
The end indicator light shows the new
level.
4. Turn the programme knob to the off po-
sition to save the operation.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
It is normal that water overflows from
the salt container when you fill it with salt.
When you set electronically the water soft-
ener to level 1, the salt indicator light does
not stay on.
ing agent, liquid detergent). This can
cause damage to the appliance.