Electrolux ESI63010 Benutzerinformation Seite 46

46 electrolux
Fault code and malfunction
• continuous flash of the start/can-
cel indicator light
• 1 flash of the end indicator light
The dishwasher does not fill with wa-
ter
• continuous flash of the start/can-
cel indicator light
• 2 flashes of the end indicator light
The dishwasher will not drain
• continuous flash of the start/can-
cel indicator light
• 3 flashes of the end indicator light
The anti-flood device operates
The programme does not start
After the check, switch on the appliance.
The programme continues from the point of
interruption. If the malfunction shows again,
contact your Service Force Centre.
These data are necessary to help you quick-
ly and correctly:
• Model (Mod.)
The dishes are not clean
Limescales particles on the
dishes
The dishes are wet and dull
There are streaks, milky
spots or a bluish coating on
glasses and dishes
Dry water drop signs on
glasses and dishes
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
• Close the water tap and contact your local Service Force
Centre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
The cleaning results are not satisfactory
• The selected washing programme is not applicable for the type of
load and soil.
• The baskets are loaded incorrectly so that water cannot reach all
surfaces.
• Spray arms do not turn freely because of incorrect arrangement of
the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
• The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
Possible cause and solution
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........