11 Programming The Machine; Programming Menu And Service Menu; Programming Controls - Saeco Office One Bedienungsanleitung

Installation of the machine - Service Provider Manual

11 PROGRAMMING THE MACHINE

All the operations described in section 11 must be performed
exclusively by the service provider or a specialised technician,
who must organise all the operating sequences and use suit-
able means to ensure strict compliance with current safety regulations.
The specialised technician or service provider can change some machine op-
erating parameters according to the personal needs of users.
There are two menus that can be used:
1 Programming menu;
2 Service menu.
11.1

Programming menu and service menu

To access the programming menu and the service menu, proceed as follows:
1 Turn off the machine by pressing the ON/OFF switch,
2 Press the espresso button and simultaneously turn the machine back on by
pressing the main switch.
Sections 11.3 and 11.4 list all of the functions available in these menus.
The menus must be PASSWORD protected.
The preset PASSWORD (default 0000), must be modifi ed during
the machine initialisation phase to prevent access of unauthorised
personnel. It is necessary to modify the password for both the service
and the programming menu.
Using the appropriate controls, select:
1. Programming menu Access to the programming menu
(password is requested).
2. Service menu Access to the service menu
(password is requested).
3. Exit Allows exiting the machine programming
• 42 •
11.2

Programming controls

When you access the machine programming or service menu, the keys take
on different functions.
"Page up/edit" key
This key enables you to:
1 browse the pages of a menu;
2 change parameters once they have been made editable with the "OK"
key.
"Page down/edit" key
This key enables you to:
1 browse the pages of a menu;
2 change parameters once they have been made editable with the "OK"
key.
"OK" (ENTER) key
This key enables you to:
1 select the function displayed;
2 make a parameter/value editable;
3 confi rm a parameter/value once it has been made editable.
"ESC" key
This key can be pressed to exit without saving changes to the edited or se-
lected parameter.