Using The Machine - Saeco Aulika SUP040R Installations- Und Bedienungsanleitung

5 Press the " " button (18) for access.
6 Press the " " button (24) until the "WATER NET" option
can be selected.
WATER MENU
HARDNESS
WATER NET
ENABLE FILTER
ACTIVATE FILTER
7 Press the " " button (18) to access.
WATER NET
OFF
ON
8 Press the " " button (24) until the "ON" option is selected.
WATER NET
OFF
ON
9 Press the " " button (18) to CONFIRM the function
activation. The "WATER MENU" menu appears on the display.
WATER MENU
HARDNESS
WATER NET
In this case fi lter management menus can not be used, so they
are disabled.
Press the " " button (23) repeatedly to quit programming.
The following alarm is displayed:
EMPTY
WATER TANK
- for 5 seconds if the water tank is empty or the water level is
below minimum threshold;
- as blocking alarm if the water tank is full.
Machine Installation - Service Provider Manual
Warning! The tank must be totally emptied of
any residual water to prevent the formation of
bacteria. Remove the "Intenza+" fi lter as well (if any).
4 When the logo is displayed, the machine is ready for use.
The " " icon indicates the correct setting for water network
usage.
4

USING THE MACHINE

After installing and priming the water network operation mode,
the machine works normally and the water tank is not to be fi lled
again.
5 DESCALING
To perform descaling cycle, please refer to instructions in the
10.7 section of the supplied manual. The machine automatically
manages the several phases to complete the full cycle.
• 11 •